I did this tie as a quick try and it only came out very light . It is from China lol
Sent from my SM-G900F using Tapatalk
I did this tie as a quick try and it only came out very light . It is from China lol
Sent from my SM-G900F using Tapatalk
Try about 350 and see what happens. I have just googled temp conversions and that is about the temp you need
Sent from my iPhone using Tapatalk
Many thanks
Iain
Equipment used A4 Ricoh printer, HP3085 Heat Press Graphtec cutter, Jarin mug press, CJV 30-60 solvent printer and lots of help from DSF.
Ahh fab. Thankyou
Sent from my SM-G900F using Tapatalk
And what about timing?
Sent from my SM-G900F using Tapatalk
I always place something between the pillow case so that the ink doesn't go through to the other side
Sent from my iPhone using Tapatalk
Many thanks
Iain
Equipment used A4 Ricoh printer, HP3085 Heat Press Graphtec cutter, Jarin mug press, CJV 30-60 solvent printer and lots of help from DSF.
Sent from my SM-G900F using Tapatalk
Thankyou for your help. It's a minefield isn't it?
Sent from my SM-G900F using Tapatalk
Your supplier should have something on their website about pressing times if not then any sublimation suppliers website normally has times and temp guides.
Sent from my iPhone using Tapatalk
Many thanks
Iain
Equipment used A4 Ricoh printer, HP3085 Heat Press Graphtec cutter, Jarin mug press, CJV 30-60 solvent printer and lots of help from DSF.
Thankyou
Sent from my SM-G900F using Tapatalk