Hi all
I am sure that this has been seen before but I have tried a few suggestions from this forum with limited success, my problem is that my Black mugs all have a brown tinge to them, from what I have read on here this could be down to over cooking? so I have reduced my time and temp as shown on another post, my set-up and times are shown below, any thoughts of what else I can try?
Ricoh SG-3110DN
PowerDriver-v4
Sublijet R inks
True Pix paper (Printing on the white side)
PixMax mug press
Settings that I have tried:-
Idle temp (120c) 248f – Press Temp (190c) 374f – Time 140 seconds
(This is giving a dark brown, almost black appearance to the mug but is fully printing to the bottom)
Recommended settings from another post.
Idle temp (110c) 230f – Press Temp (170c) 338f – Time 120 seconds
(This is giving a very brown appearance to the black and is fading out to the bottom of the mug; we only print 4 mm above the bottom)