Hello - to all those members that currently use a ChromablastR set up, can you tell me approximately how much a full A4 print works out at please? I realise 2 prints aren't the same, but I can't find any info on ink yields.

many thanks
lisa

<t>Hello,<br/>
<br/>
Having trouble with print quality. I'm printing black on to white and after it's printed I'm left with 2 feint (but still visible) lines running vertically through the design. I'm sure it's from residual ink left on the rollers, but not sure how I clean them. I've cleaned and ...

I just tried 4 prints on a sheet of A4 and it's perfect, I suppose I probably should revert to this method...

thanks to everyone for their help - be assured I'll be a regular!!

Ok I'll try it later today. I thought it would be more economical to buy the pre sized paper, it just seems such a waste printing on A4.

Will let you know how I get on.
Thanks again

<t>i think this is where I'm going wrong.<br/>
<br/>
Ok, from the start, I open up Corel and choose 'New Blank Document'<br/>
I select size 'custom' and enter size 90w x 140 h<br/>
I them import image and centre via the 'arrange tab' My image is 67 x 125<br/>
I then go to 'layout' and 'page set up ...

It's pre cut from Marvel for use with the sublicase - measures 140 x 90 mm

I just printed out a square on A4 paper using the original printer drive and it came out perfect and centered. But I wanted to use the pre cut iphone paper when printing the phone cases not A4.

<t>Thank you for the fast replies, I shall try your suggestions.<br/>
<br/>
Re; the paper size, I entered a custom size which was special iphone paper 90 x 140mm. If I printed it on A4 and selected A4 in the paper size the design image does appear a lot smaller in print preview and is centered and ...

<t>Ok, here goes,<br/>
<br/>
I'm new to sublimation (and the forum - hello!) and have just bought a basic sub-print set up. A GXe3300N printer, flat bed press and CorelDRAW 6. I installed the original printer driver, then installed the Sawgrass powerdriver, I configured the settings in CorelDRAW and ...

<t>Hi, <br/>
<br/>
I'm new to the forum and new to print/sublimation etc. hoping to gain some pearls of wisdom from the experienced among you - so many questions....<br/>
I'm an accessories designer and thought I'd branch out into printed surface design, proving tricky to get the set-up right. Hope ...