I've sent them an email, and am waiting for a response, but I get impatient and I want to play with the mug press :rolleyes:

<r>Hi All<br/>
<br/>
I just purchased the mug press from The Transfer Press and some sample bits for the 72mm diameter mug element. <br/>
Does anyone have some basic set-up times and temps that they use that I can use as a base to fiddle?<br/>
I have tried pressing 2 of the thermos cans but both ...

It's a free sub one, I think I got it from dyesub supplies

I have one of these and it gets the job done nicely

Everything else I have printed works fine, t-shirts, metals, hardboard coasters and jigsaws.
I have even tried turning the coasters half way round to see if that helps

<t>Hi<br/>
<br/>
I have purchased some glass coasters from bms and struggling to get a decent print.<br/>
I am currently pressing at 190 degrees for 150 seconds but the middle of the coaster is slighlty cloudy and generally the colours are all a bit dull. (I also tried 120 seconds at 200 degrees)<br ...

<t>I have been looking at a few 3D vacuum presses on ebay as a new toy, but is there a demand for the items that can go in them?<br/>
I'm not looking into doing mobile phone cases as I would need to stock so many blanks it would make it too fiddly, but I was looking at latte mugs, shot lasses ...

<r>Hi, <br/>
<br/>
I have a small print/copy shop and try to focus on short print runs and one off sublimation gifts. I am always on the look out for new toys play with and I am sure I will be asking many questions <E>:)</E><br/>
<br/>
I started sublimating in early 2015 so compared to some of you I ...