Cameo Driving me up the wall

[Bob700]

Hi
Now that I have the thing cutting more often than not it leaves out a letter on the vinyl. I stay within the perimeters of the red square, I didn't have any of these problem using a Craft Robo with Studio software....any ideas where I may be going wrong

Thanks

[NikGrey]

Downgrade Designer Software to 2.9.45 - I have been through all of these problems too, finally settled on a version which just works.

[viccar]

Are you using a mat?
If not have you selected load mat instead of load media?

[viccar]

Bob the best thing to do is have a spare couple of hours and you tube cameo videos, you will learn so much

[Bob700]

Hi Viccar
Yes I think youtube will give me some good videos to study

Cheers Bob

[Vynmarius]

Where its not cutting the letter, is your adjustable pinch roller going over it?

[NikGrey]

Did you try using the same software version I suggested? I had exactly the same problem - this solved it.