Needle Bar Misaligned? Tajima Neo TEJT C1501

[Stitch Up]

Hi guys

If I manual pull down needle bar 12 on our Tajima Neo TEJT C1501 machine, the needle tip is out of alignment with the hole in the bobbin plate!

How can this be remedied?

Cheers

John

[logobear]

just bend the metal back .... you probably hit a hoop at some stage ?

[Stitch Up]

Thanks for the reply - I always shy away from bending things :)

I'll give it a try later.

Thanks

[logobear]

if it goes wrong, just swap it for one at the far end that you rarely use !

[Stitch Up]

Done that :)