PDA

View Full Version : JML Halogen Oven for mugs



what a mug
27-08-2011, 01:10 AM
Hi, Ive just bought a JML halogen oven for mug sublimation. What are the advised wraps as I see many on the market and obviously each manufacturer states theirs is best...

HELP : PLEASE

SciArtImages
27-08-2011, 01:30 AM
Hi,
I recently started printing mugs and bought the clamps from BMS - have to say they are very good and I'm very happy with the results. The only adaption I made (being a bit of a tinkerer) was to chop up a silicon baking tray and put slithers between the metal and rubber of the clamp to print as close to the handle as possible - before if I held them up to the light with a mug clamped in I could see daylight.
But I would definitely recommend these clamps. One tip with the oven would be to use the extension (if it came with one) - I scorched the paper onto the mugs without it - see how close the element is to the top of the mug.
Neil.

what a mug
27-08-2011, 06:26 PM
Thanks Neil, I didn't get the extension but ill purchase one anyway..
Regards
Martin

Renniwano
26-10-2011, 09:41 PM
I know this is an older thread.. but wondered which size these ovens were.. I have looked into the 12-17ltr ones.. but have seen them from as small as 7ltr

Nikki xx