View Full Version : GOLDCUT JK Series
Dave271069
13-04-2013, 11:39 AM
Right im having a little difficulty in setting this up on my pc, GOLDCUT JK Series driver will not go onto windows 8 has anyone else put a Chinese cutter like this onto a new pc with 8 on it? it wont let me install the driver, i will go and get my laptop out of caravan in a min and try it on windows 7, im using instructions from lovecut refine cutters
Dave
Dave271069
13-04-2013, 01:49 PM
Can you tell me if you look in your printer selection on pc will a chinese plotter be here as a installed printer?
Justin
13-04-2013, 01:58 PM
Only if you've installed it as a printer, otherwise no.
Dave271069
14-04-2013, 05:39 PM
In my control panel under devices and printers my cutter appears as UNSPECIFIED and USB-SERIAL CH340 (COM4)
can anyone tell me if this means my pc has recognised my vinyl cutter and is ready for software.?
yes it is. jus in software setup make sure your cutter is set for com4.
Dave271069
14-04-2013, 06:15 PM
Thanks Paul,
im getting there slowly, signblazer is playing up now, but before i try and cut something does anyone know what lights should be on or off on the cutter?1746
image is poor red light is RESET under neath is ONLINE/OFFLINE under that is SETUP
Powered by vBulletin® Version 4.2.2 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.