PDA

View Full Version : Pressing plates



Greensleeves
07-05-2010, 06:53 PM
Hi all
I have pressed about 3 10 inch plates and on one i noticed a pattern in the middle of the picture. I looked at the press itself and there are no patterns on it. Did anyone here have this problem? im putting it down to the plate as nothing could be seen in the print on the paper. Did not see a recess in the plate where this problem occured. Moving over to a new system slowely but if anyone has advice it would be appreciated. And before anyone tells me yes i did keep the paper smaller then the size of the press.

Thankyou
Patrick :D