a few more words
06-11-2013, 07:24 PM
We have had problems today doing some Easel back Unisub boards,
2085
Pressing at 200c / 60 secs
As you can see from above , we got a very poor result, .......we suspected that the pressure was not enough, so we increased it and did another one
and got the following improved result
2084
Which was a good improvement , but still not good enough.....the pressure was high for this .....(manual press)
I guess the poor result is because of poor pressure being unevenly transmitted due to the easel on the back of the 6mm board.
I was next considering making up something of similar thickness to the actual easel to sit alongside the easel , so that the full board is supported evenly ????
Does anyone else have a better way ??? Some tricks on this one ??
Thanks
Tom
2085
Pressing at 200c / 60 secs
As you can see from above , we got a very poor result, .......we suspected that the pressure was not enough, so we increased it and did another one
and got the following improved result
2084
Which was a good improvement , but still not good enough.....the pressure was high for this .....(manual press)
I guess the poor result is because of poor pressure being unevenly transmitted due to the easel on the back of the 6mm board.
I was next considering making up something of similar thickness to the actual easel to sit alongside the easel , so that the full board is supported evenly ????
Does anyone else have a better way ??? Some tricks on this one ??
Thanks
Tom