Printable View
I have been offered an epson 1400 with ciss system (sublimation) for free. it hasn't been used for over a year and the guy suspects it is clogged... Is it possible to get these printers back to good working order or will it just be a waste of my time trying to clean it? any tips on where to start if he head are blocked. Thanks
Epson support centres charge £30 to attempt to unclog (using cleaning solution, time and effort). Worth £30 anytime. Check to see if you local Epson Authorised repair centre offers the same (locations on Epson's website).
if its for free you only have time to waste
...er, but time is money!
If he only "suspects" its clogged, then it's worth a gamble. Most of the time I find that my Epson 1400s (that I don't use much now), fire up quite well after a couple of headcleans. If there is a stubborn colour then leaving it overnight tends to deal with it 90% of the time.Quote:
Originally Posted by eburb
It's worth a try just to see if it's not as bad as the guy thinks.
The ink itself might not be much cop after a year, though. Getting some OEM carts and popping them in would probably serve you better than forcing out-dated and aged sublimation inks through the heads (dye-sub ink is typically thicker than regular dye ink).
Thanks all,hink i will have a play with it and see how it goes - hopefully get it sorted
only if you cant employ good time managementQuote:
Originally Posted by pisquee
Hi i had problems with magenta on my epson 1400 and artaniumUV CIC inks.
Did everything recommended in the forum and web suggested to sort out the problem but had no results. I then replaced the print cartridges etc etc and nothing happened ended up buying a new printer thinking it was the print head and still it didnt work. To cut this long story short the only thing i didnt repalce was the bulk ink holder itself! contacted sawgrass and they replaced the system and all worked ok.
But this is the second time in three years this has happened and with the same magenta ink so i do believe if you don't print on a regular basis the inks dry up in the piping and leave a skin which blocks the pipe on the base unit.
Many members (myself included) are starting to move more towards refil carts over the CIS bulk systems and finding the going a lot easier.
Thats a very good point Justin, I was thinking of starting with refillable carts.
I'm having similar problems on my 1400 too. The test print shows about 40% of the Cyan.
I have reinserted original Epson cartridges and the test print was fine. The CISS system is new ( the ink tanks that I fill up aren’t new though ). I have sucked the Cyan cartridge and it’s constantly 'bubbly'. So, I added new ink into the CISS Cyan cartridge and the test print was the same.
So I’m guessing it’s not the printer as the original cartridges printed fine. The CISS system is new. Could it be the ink tanks?
Any help would be appreciated.
Have you tried sucking a fair bit through to see if the bubbles go? Sounds like an air leak to me.
Did the ciss not come with ink tanks?
Make sure anywhere there is a link/joint/valve on the cyan line that it is tight.
If the system is new, I'd be asking your supplier for support - if not you could try some glue of some kind to make sure all the joints are sealed ... but be careful that the glue doesn't actually go into the lines and block them!
I have tried sucking the ink through the printer cartridge side but the bubbles kept coming through.
We didnt get ink tanks as we had problems with our old CISS so didnt need new ink tanks before.
Many Thanks
where would the air leak be?
the air leak is most likely to be at any of the joints in the system - it is unlikely that there is a hole in the actual tube, but possible one of the joints has come loose.