Search:

Thanks a lot for your reply Ray, very helpful!

I got some sample sheets of Versa paper when i bought the printer so will give that a go next time i need to do coasters.
Other than this curling...

Hi guys, I'm printing 6 9x9cm coasters per A4 sheet. At the top and bottom of the page I'm getting scuffs where the paper curls up a little once printed and clips the print head. Attached a picture...

I did 195 degrees, 65 seconds. Same on both sides but let them fully cool between presses. No burning, blurry print or change in colurs to the existing printed side.
Found out I got a much better...

Thanks for your help guys. Had a day of mug and bar blade printing/pressing and it was very successful thankfully!

Great thanks John. I'll give them a go tomorrow and see how they turn out.

Hahah thanks for that! I'm anticipating a whole new set of problems doing them

Hi guys, just wanted a bit of guidance with regards to the metal bar blade bottle openers. Purchased from Isub Supplies and printing on both sides is possible on them.

1. Should I print both...

Awesome, thanks that!
Going to spend my Saturday giving them a go. Hopefully it'll be a stress free day...

Hi guys, I'm new to sublimation printing but experienced in heat pressed garments and other printed merchandise.

I wanted to ask whether I should be using a silicone sheet when pressing the...

Just became a premium member. This site has so much great info on it!
Looking forward to being upgraded as I've got my eye on a heat press I'd like to use the discount on :)