Search:

Thanks for that info. I am using just one piece of rubber at the minute and it is the same size as the platen so it is presumably centered ha.

If I ever get it figured out I will remember this...

Just a little update, (if I get no responses on this thread, I'll probably start a new one)

I have purchased a new rubber pad as I had read sometimes these wear in the middle so current set up is:...

Todays results were better, I think the waving effect was due to the wrinkling of the chip shop paper under the garment (I had this here to protect the press from ink as I sometimes do a back and...

I am using the baseball/raglan shirts by Vanilla. They are great quality. Seems we are using a similar set up, I will try adjusting the time keeping the pressure the same and wish for the best.

I wouldn't say so as this is sold as a sublimation shirt from xpres and I have used them before without any problems.

I wonder if I need to adjust my press settings or maybe my colour profile?

Hi, I have now managed to get all seams outside the press or at least lower than the area to be printed so success?! No, sadly not, I have now replaced my problems with more problems.

In the...

Thanks everyone for the suggestions.

I have ordered a 4mm silicon pad so I can try it out. Bonus for these is I can get custom sizes compared to the pillows and unfortunately I don't have any old...

Ah thank you very much!

Is there a supplier you recommend and thickness?

Hi everyone, first time posting but have been reading for a few years ha.

I have been sublimating for a few years now (not the primary focus of our business initially but moving onto it a bit more...