Has anyone ever tried to profile their printer, transfer media and media for phone case? If so, what is your set up, what is your profiler and how did you go about profiling your cases?
I'm currently using a SpyderPrint 4 to calibrate my printer and although the profile is CLOSE, it's still off with some color.
My setup
Printer: Epson 1390
Ink: Low Temperature DyeSub Ink
Transfer media: Sublimation film (white opaque one)
I tried profiling on iPad Air (the largest media to get the whole print target at one go) and although I think the result was not bad, it was a miss for some of the colors (a reddish shift for the beige color).
Any tips or hands-on experience would be much appreciated!
Thanks!