Hi All,
Bit of a strange one here - trying to print a full page photo to sublimate ...
But I am getting lines near to the font and end of the picture.
See attached picture for reference,
Now I have been battling with cyan to try and get a full nozzle check but keep failing to get a full cyan output.
See picture for a nozzle check report, cyan is almost complete but I can never get it full (But it did use to be) Even after mutiple head cleans and also syringing cleaing fluid through the cyan print head this is the best I can get..
(Cyan is far right, looks darker on a picture..)
Would having that not full give me the problems i am experiencing in the full page print out ? Why only at the begining and end ? In the middle it looks fine so if the head was blocked wouldn't i be getting lines everywhere ?
I also printed out a test chart and that look ok too - see picture below ..
Could anyone shine any light on this issue ? It is very annoying !
Printer is an Epson WF-3010 running CISS ..
Thanks.