Hi
Been testing out designs on some new products we are working on and I still seem to have problems when it comes to the weeding and masking. When I'm peeling the excess vinyl away parts of the designs lift up and start to come with it so have to push them back down. Is this suppose to happen? I try to be careful and go slow but it's hard to see what you are doing. I tried increasing the cutting force and did a test cut and seemed fine like it did the time before on a lower cutting force but it still did it but this time in a couple of places it cut right through! How can it cut right through in places and not others?
re masking, I cut the sheet up into say A3 size pieces and then try and peel the mask backing off without creasing it and then slightly fold it and put down in middle and carefully work my way outwards and then use squeegee to get out any air bubble but if you happen to get a crease in it then it's a mess!
I ran out of vinyl and started to panic on what was going to happen when it got to the end and was quite surprised that it actually stopped and went and cut what I did so the vinyl wasn't wasted.
Can you run off say 2m of designs in one go or is it best to do smaller runs so it doesn't hit the floor?
Thanks
Lianne