Hello,
I'm currently trying to use the ST3042 machine with Sawgrass SG400 printer for phone cases but quite disappointed from the heat press and hope that here I could find help from you!
The issue is not in corners, its normal that corners are not perfect, the issue is consistency and resolution. So the process I'm using is heating up the jig for around two 7 minute cycles of 190 degrees and what happens is that usually the first case comes up okay, but the next one or third one comes very blurry and I find it almost impossible to control this. Also at times the phone cases don't shrink enough and customers complain that they are too loose on their phones.
Do you experience similar issues and how do you overcome them?
Thanks,
Ilian