Hi everyone
I'm new to this forum (and printing) so please excuse any incorrect terminology!
I'm trying to print a design onto EVA foam interlocking mats (not polyester coated - straight onto the foam). I've been told its not possible for several reasons, the image bluring, print rubbing off, bowing under the heat but I found a supplier willing to give it a try on an A4 sized sample. Couple of photos attached. I'm very pleased with the results, it seems very durable but has slightly bowed.
Does anyone know how it might be possible to stop it from bowing? It was heated at 180 for 40 seconds. Its only very slight so you might not read it on a larger tile.
Also I'm struggling to find anyone in this country to print these mats. Any ideas for where I could get these printed?
Thanks for your help
Sarah