Hi,
I recently bought a setup that included an SG7100DN with Sublijet cartridges (out of date and empty).
As the printer was unknown and well out of warranty I went with refillable cartridges for it (Amazon) and dye-sub inks.
The printer is communicating with both the MacBook and my laptop and I successfully flushed the lines with de-ionised water... so far, so good, but the system was telling me the waste ink tank was full, so I replaced it.
On installing the refillable cartridges the printer goes through the initialisation for a few minutes and then stops with SC20222, suggesting turning off and on again. I've repeated the process a few times but always the same. Ricoh didn't recognise the code but I found a service manual online and bought the download. the code points to Tank 2 not achieving negative pressure. What I then did was swap the cyan refillable for the empty Sublijet one... restarted and the error was gone. I swapped them again and the error returned... repeated with the Sublijetcartridge, error was gone.
Great! thought I.
I contacted the seller and they were very helpful and sent me another set of refillables as well as a bottle of cyan to replace that used.
Once it arrived I fitted the new cyan and... SC20222 was back. Just for good measure I put the Sublijet cartridge in and the error was gone.
I've tried a couple of Ricoh service companies but they both say they no longer support the printer.
I'm left with three options right now:
- Buy a single Sublijet cyan (approx £35) and hope that the rest of the printer is okay
- buy a new printer.
- ask you nice people for advice/experiences.
I paid £50 for the printer and have spent about £85 on inks, cartridges and waste tank so I'm about £130 - £140 in on this machine.
Thoughts, anyone?
Steve.