Having a nightmare with all these different mugs I'm having to use. Normally have the Coralgraph mugs, but due to shortages and covid I'm having to use what I can.
The mugs I'm on at the moment are either the j.s coatings 10°z or the orca coated MDP mugs.
For what ever reason even though I'm tapping around the bottom as usual on certain colours the mugs are patchy or, they are gassing at the bottom.
I'm pressing the mugs at 185° for 250 seconds. And they look crap. I've lowered the time and raised it but to no success. I warm the mugs at an idle temperature of 160° and use touch to feel if the base is at the right temp prior to pressing... Any advice would be appreciated.
I'm using a freesub st201 with sublinova inks and ink experts 120mg sublimation paper.
TIA.
Sent from my Redmi Note 9S using Tapatalk