Hi guys, just wanted a bit of guidance with regards to the metal bar blade bottle openers. Purchased from Isub Supplies and printing on both sides is possible on them.
1. Should I print both sides at the same time or one side at a time? I'm guessing one side at a time is preferred as it'll be easier to line up perfectly.
2. Is there a change in press settings for the 2nd side press? Should I let the blade cool/douse in water before pressing 2nd side?
3. Is a full coverage print OK or is it likely the print will chip and wear quickly with regular use around the opener area?
4. Should I press with hot plate on the sublimation paper side, or flipped over pressing onto the metal
Any help would be awesome!
Thanks
Matt