Hi

Come Christmas I'm going to need to print a lot of coasters, I can't tape these individually (time/cost will not permit) so I will need to print these in some sort of jig. I've tried a few dozen UniSub coasters in a MDF jig from MDP without issue but obviously the challenge is produce rather more than a few dozen so I'd like to understand what problems develop over time......

I've read a few posts on here where people have tried with jigs (and mostly ultimately failed - unless someone can tell me different!). I'd be grateful if anyone can share their experiences of using jigs and the issues they encountered so I can try and build a solution with as few problems as possible.

Thanks

Gary