Hi All
On some mugs I get either a faded image at the top or bottom (usually bottom) of design & sometimes a thin black line. I don't know if this is an issue with my mug press which is fairly new with light use or if I am making the transfers too large.
I usually leave about 5mm top & bottom but I wonder if this is enough or if the problem is something else, I do try to make sure that the transfer it tightly wrapped around the mug & that the mug is quite tight in the press, I have an Richoh SG3110DN printer & I am pressing at 170 for 140 as various people recommend these times to prevent browning with Ricoh's.
Any pointers or advice appreciated.
Regards
Eddie