GOLDCUT JK Series

[Dave271069]

Right im having a little difficulty in setting this up on my pc, GOLDCUT JK Series driver will not go onto windows 8 has anyone else put a Chinese cutter like this onto a new pc with 8 on it? it wont let me install the driver, i will go and get my laptop out of caravan in a min and try it on windows 7, im using instructions from lovecut refine cutters

Dave

[Dave271069]

Can you tell me if you look in your printer selection on pc will a chinese plotter be here as a installed printer?

[Justin]

Only if you've installed it as a printer, otherwise no.

[Dave271069]

In my control panel under devices and printers my cutter appears as UNSPECIFIED and USB-SERIAL CH340 (COM4)
can anyone tell me if this means my pc has recognised my vinyl cutter and is ready for software.?

[Paul]

yes it is. jus in software setup make sure your cutter is set for com4.

[Dave271069]

Thanks Paul,
im getting there slowly, signblazer is playing up now, but before i try and cut something does anyone know what lights should be on or off on the cutter?Attachment 1746

image is poor red light is RESET under neath is ONLINE/OFFLINE under that is SETUP

[Arbydoo]

Hi, We have moved to France from the UK and have been trying to reset up our KH-720 cutter. I have unfortunately lost disk 1 but still have disk 2 with Artcut on it.


Can anyone advise where I might be able to get the drivers for my cutter.

Many thanks in advance

Arby

[Justin]

Is it just the USB driver? I have one for an old cutter here but it was a 721 model, wonder if it might work?