See HOW to print on a Mug Base Ear.
It's a Saturday Night, I'm in my forties so it's time for me to change into Heath Robinson.
Decided to try and Sublimate a Mug Handle.
Knocked up a Jig in an hour, basically this just holds the mug with the handle upright.
Use the Cap attachment of your cheap Chinese 50 in 1 bundle.
Let's begin:
Make a 50mm x 10mm template in Photoshop etc and make your design - print it of course in reverse and tape it in place as above.
Slip into super dooper technical Mug Jig.
Allow blanket to reach idle temp (220f in my case) - probably best to use something as a heat sink to protect the blanket but I havent worked out the best way of doing that yet with my new high tech system.
Press:
I am keeping all of my times/temps the same as I have to use the same controller for Mug Bases, Mugs and now Andles.
190c for 190 secs.
And the result.... :
I would imagine all Sublimation Mugs have a coated Andle.
I am quite pleased with the result.
Edit: as you can see I used a scrap mug for this test - it is faded at the edges (cheap Mug Press).