Might be a stupid question to some but is there a trick?

I don’t normally apply printed vinyl to correx but I have been asked to supply about 20 a2 sheets with a full page print.

so my question is how do I align the print with the correx when applying it?
In the past I have sprayed the vinyl and correx and moved it about until I was happy then squeegeed out the water mix.

this isn’t a good way of doing it and I though there must be a way that’s far easier.
for info I print and cut the image to a2 size and trim any excess correx or vinyl and use my laminator on a light pressure setting.

many thanks.