Page 2 of 3
Re: ChromaLuxe Panel Printing video
Posted: 13 Oct 2012, 21:07
by bms
crystaluk;56168 wrote:Looks great!! Where did you get the jig from?
5mm thick mousemat and a sharp knife (or I'm sure Paul will sell you one already cut for a lot more than the cost of a mousemat and a sharp knife
)
Re: ChromaLuxe Panel Printing video
Posted: 13 Oct 2012, 21:19
by Paul
Lol. Yeah. Will sell jig for £10
Any one???
Re: ChromaLuxe Panel Printing video
Posted: 13 Oct 2012, 22:53
by crystaluk
Paul;56171 wrote:Lol. Yeah. Will sell jig for £10
I think you added the zero by mistake? Lol! It's a superb idea so creative
Re: ChromaLuxe Panel Printing video
Posted: 15 Oct 2012, 08:51
by stuart
thanks paul fantastic as always
do you not need to use a cover sheet on top when pressing ?
stu
Re: ChromaLuxe Panel Printing video
Posted: 15 Oct 2012, 09:54
by Paul
Do you mean silicon?
Re: ChromaLuxe Panel Printing video
Posted: 15 Oct 2012, 10:30
by stuart
silicon or paper
stu
Re: ChromaLuxe Panel Printing video
Posted: 15 Oct 2012, 11:11
by Paul
Iuse teflon sheet.
Re: ChromaLuxe Panel Printing video
Posted: 15 Oct 2012, 13:03
by stuart
just wondered cus in the video you never used anything
stu
Re: ChromaLuxe Panel Printing video
Posted: 15 Oct 2012, 13:15
by Paul
Yes. Know. In this case there was no need as the paper was much biger then print. but normaly i would use teflo sheet. I also use copier paper .
Re: ChromaLuxe Panel Printing video
Posted: 15 Oct 2012, 14:58
by stuart
thankyou paul
stu