Page 1 of 1
Re: Iphone 5s jig
Posted: 04 Apr 2016, 12:34
by we-print
Do the metal jigs/moulds expand over time? All of a sudden my 5s blanks won't fit on.
Sent from my SM-N910F using Tapatalk
Re: Iphone 5s jig
Posted: 05 Apr 2016, 20:07
by socialgiraffe
Mine haven't, I would have thought it's the cases in my opinion.
Sent from my iPhone using Tapatalk
Re: Iphone 5s jig
Posted: 05 Apr 2016, 20:34
by we-print
Thats what i thought but the new ones don't fit either. Any chance you could send me one?
Sent from my SM-N910F using Tapatalk
Re: Iphone 5s jig
Posted: 05 Apr 2016, 20:37
by socialgiraffe
Case or jig? I have both spare. However how are you printing them? Times, temp and machine.
P.S. I will not be able to send anything until next week as I am just off on a short break
Sent from my iPhone using Tapatalk
Re: Iphone 5s jig
Posted: 05 Apr 2016, 20:54
by we-print
A case would be great in case the new ones are the same as the old ones.
I preheat the jig then press for 1'50 at 180.
The cases i have at the moment wont go on the jig cold either.
Sent from my SM-N910F using Tapatalk
Re: Iphone 5s jig
Posted: 05 Apr 2016, 20:57
by socialgiraffe
That's not right as they should fit cold. PM me your address and I will send a few as soon as I am back. If you can get them on then try printing with just the top oven on. So pre heat a jig for 30 mins ish then 180 degrees for 6 minutes. Some cases prefer that method.
Sent from my iPhone using Tapatalk
Re: Iphone 5s jig
Posted: 12 Apr 2016, 15:53
by Ravisteam
I am sure your new stock is different to ur old stock ..Ive seen some differences of stocks time to time..even the cooking time need to be changed some times...