DSF

Hi all,

I'd like to make a profile for my Ricoh SG3110 and am considering either the ColorMunki Design or Photo. What would be better for sublimation mug/shirts designs?

From what I've read the 2 x 50-patch charts aren't very thorough and I'll need to create a different profile for EVERY design/picture I have.. is this correct? If so isn't there a calibrator that can make a single/good all-round profile?

In the UK so if you could point toward a seller that would be great.

Thanks

The two patch charts are fine, then over a few additional prints just do an additional chart. After 5 varied prints you will be dialed in for nicely.
I have used a colormunki photo for a few years now and it works a treat. Bought it at a trade show where they matched the lowest internet price.

Not used it on my ricoh as that runs Sawgrass and Trupix. Have used it on a range of epsons with sublinova and jetstream.

Janners