DSF

Hi, duplicated post, thought I had started it in the wrong place before, apologies,

Hi, have spent a while trying to figure out how to contour cut multi-images on the summa d60.

I printed out the registration marks in x and y axis, aligned the load on the cutter by moving the cutter over the registration points and entering the position on the cutter, have tried to enter the disatnce between the x and y positions on the software(using flexisign 7.6) but can't seem to get it going

Would be very appreciative of any advice anyone could give.

thanks

Unfortunately the Suma D60 does not have contour cut I don't think. I have a D60 and have tried many things without success. I know Flexi 7 does contour cut but as far as I know, your machine will not read it.