DSF

Hi,

I have bought a pneumatic heat press for sublimation printing but I am a little confused regarding the pressure setting. The mat I am trying to sublimate states that I should use 5 bar pressure but my press range is from 0 to 1 so in my case is 0.5 equal to 5 bar pressure – any clarification on this would be great.

Thanks!

Hi,

Could you state which pneumatic heat press you purchased, maybe then someone on here can help you out.

there will be a pressure guage that gives the actual pressure, - the pressure knob is just a relative up/down valve.

5 bar is a lot for sublimation, - normally only need enough to stop any movement .....