DSF

MagiCut 6.0 Pro does it work with cameo cutter.

Well info on TMT website about what it does support seems to be non-existant. However google did throw up a number of people using older craft robo cutters with it. So the simple answer from me is maybe lol

I did think this when I phone magic touch I could hear them talking in the background, and one of them yes or no make your mind up, then some said say no. have you any links I can get to see what can be done, I've tried but couldn't see anything, maybe I didn't use the right words

http://www.magicut.com/contact.html

Try completing this form and asking the americans.

However there are almost certainly a number of other cutter packages that do similar. I would take a look at what Flexisign and WinPCsign offer also and I am sure there are other packages worth considering also.

Thanks, just done will post the answer when I get it, the software does sound good though.

I've had no reply from them, any suggestons

Well they may be 8 hours behind us so may only have just started working. But if they do not know and cannot reply then what is the chance of getting support when you need it? I would suggest you do not purchase at that price until you've looked at the competition and got confirmation of suitability.

WorthDoingRight;53893 wrote:Well they may be 8 hours behind us so may only have just started working. But if they do not know and cannot reply then what is the chance of getting support when you need it? I would suggest you do not purchase at that price until you've looked at the competition and got confirmation of suitability.

Its ok I would not have purchased till I heard, it's just not my week, every order I've tried to send has gone a bit haywire, hey ho I shall keep muttering under my breath, I'm starting to sound like a grumpy old git. My husband has taken to wearing ear muffs.

I've sent another email but I'm not holding breath