DSF

Spending an hour removing a wrapped OBM 5.6 transfer from a laser printer roller!

It's been a few months since I did a transfer and I should have checked all of the settings.

Soo..... write out 100 times:
I will put the transfer in the manual feed tray and set to the correct thickness


Dismantled laser printer fuser assemblies are hot! Unfortunately I had to keep it hot so the transfer remained gooey enough to remove.


I wonder if I can cock-up pressing them now

Mark

Well I have had to remove a few MugsNMore sheets that were melted inside my OKI printer due to overheating even from the manual path. I do wish they would assist us all by telling us which are the 'cooler' print options.

I hope you are successful with your pressing.