DSF

Hi All,

I was hoping you could help?

I have recently bought a mini 3D sublimation machine and have been reading through the 3d sublimation threads but wondered if anyone had any success stories on the temperate/times and any hints and tips.

is it best to use the mug clamps or the silicone vacuum?
Any help is much appreciated.

Many thanks

I used mug clamps with excelent results

that's brill thank you Paul I will use the mug clamps, what temp and time did you use?

here are the results.
http://www.dyesubforum.co.uk/vbforum/sh ... #post92303
i had it for 180C and 770sec. but people say this is to much

mugs clamps here also with superb results....saying nothing paul lol

ok, ok What is the shortest you can go with 4 mugs??

So I thought I would try 190C for 300sec in the mug clamp but it did not turn out well, the picture and text on the mug were faint. I will try your settings tomorrow Paul

I'm like Paul 180 for 11 minutes 10s less than Paul

Paul;93437 wrote:ok, ok What is the shortest you can go with 4 mugs??

lol...never had 4 sales of mugs at one time to find out yet

found my vid camera - and found the power lead...now i need to find the dam cable to transfer it over to my pc...so i can show you this.....i aint telling porkys here...honest, no point tbh

and....
we are talking about single mug here and the last confab on here about times ect....was for one single phone case, and a single mug...at any one time..remember

4 mugs at one time will obviously need more time...but def not 700mins lol

i just tried 170C for 350 sec. Turn out ok ish. I started the count down as i would with my standard press, When temp stopped dropping. Just don't like sprees paper with my Ricoh and... This ricoh icc profile is winging me up!! :rolleyes: