General sub advise please?

[adamctid]

Hi, I've got a 3d vacuum heat machine, The products I'll be doing will be mugs, Phone cases, plates and shot glasses.
I am just after some general advice please? I've watched so many videos and they all seem to be different.

1, Do I need to heat up the products before I set the timer going? (do I warm up the product with the picture attached)?

2, Do I attach the picture when the ink is wet or dry?

3, Do you leave to cool before removing the sub paper?

4, do I print straight from photoshop or do I change it back to a jpeg and print it straight through the printer software?

All advice will be greatly received thank you.

[socialgiraffe]

Do I need to heat up the products before I set the timer going? (do I warm up the product with the picture attached)?

No, but should be room temperature

Do I attach the picture when the ink is wet or dry?

Dry, otherwise it will smudge

Do you leave to cool before removing the sub paper?

Personal preference, some people are dunkers, others are leavers, it will all be down to your exact set up.

[adamctid]

Thank you.